iMatrixSpray in hood – too fast drying of layers


home Forums iMatrixSpray Hardware iMatrixSpray in hood – too fast drying of layers

This topic contains 0 replies, has 1 voice, and was last updated by  Markus Stoeckli 2 years, 10 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #284

    Markus Stoeckli
    Keymaster

    Based on feedback from users, there are differences in spray result depending on the hood being used to place the device in. A major factor is the flow of air over the sample, leading to fast dehydration. Test in our lab showed that this can overcome by closing the sides and back of the sprayer, preventing excessive airflow through the system.

    You may use a material of your choice (cardboard, plastic, aluminum…) to close the 3 sides and test the results. Please report back to this forum if you have an solution which works well for you. We are currently working on an upgrade kit made out acrylic sheets which will be available shortly. While cardboard works, we thing that acrylic would add to the good looks of the device 😉

    Markus

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.